WaveTinkerbrowser audio studioSearch tools/Chain effects

Violin Tuner (Viola, Cello and Fiddle)

Play one open string and watch the needle. The tuner hears the note through your microphone, names it and shows how many cents it is sharp or flat, so you can bring each string to pitch with the fine tuners or the pegs. It covers violin, viola, cello, double bass and the usual fiddle cross-tunings.

  • Free, no sign-up
  • Runs on your device
  1. Choose the instrumentPick Violin, Viola, Cello, Double bass or a fiddle tuning from the list, and the A4 reference your teacher or orchestra uses.
  2. Start and bow one stringPress Start tuner, allow the microphone and draw a long, even bow on one open string. Tap a string button first to hear its target pitch.
  3. Center the needleTurn the fine tuner or the peg until the needle sits in the middle and the note name matches, then move on to the next string.

Updated

Violin, viola and cello strings

The violin is tuned in fifths: G3, D4, A4 and E5 from the lowest string to the highest, with A4 at 440 Hz by default. Each string sits a fifth, seven semitones, above the one before. The viola uses the same pattern a fifth lower, C3, G3, D4 and A4, so it shares three strings with the violin. The cello sits an octave below the viola: C2, G2, D3 and A3.

The double bass is the exception. It is tuned in fourths, E1, A1, D2 and G2, like a bass guitar, because fifths would stretch the left hand too far on such a long neck. Its lowest string vibrates about 41 times a second, low enough that a phone microphone sometimes hears the overtones better than the note itself; a firm bow stroke near the bridge helps.

The table in the Numbers tab lists the target frequency of every string for each setting. They are equal-temperament values from A4 = 440 Hz. Choose 442 Hz and every target moves up by the same amount, about 8 cents; choose 432 Hz and they all move down by about 32 cents.

How to tune a violin with the microphone

Tune the A string first. It is the reference string of the instrument, the one an orchestra takes from the oboe, and the others are checked against it. Bow the open A with a full, steady stroke and let the needle settle. A plucked note works too, but a bowed note holds its pitch longer and gives a calmer reading.

Use the fine tuners for small changes. Most violins have a fine tuner on the E string and many have one on all four; a quarter turn moves the pitch by a few cents. If the needle is more than about 30 cents away, or the note name is wrong, use the peg instead: push it gently into the pegbox as you turn so that it holds, and approach the note from below rather than from above, which keeps the string from slipping back.

Work in the order A, D, G, E, then check all four again. Raising one string adds pressure on the bridge and the top plate, and that can lower the others slightly, so a second round is normal and usually takes less than a minute. When every string is centered, play the open strings in pairs, G with D, D with A, A with E. A pure fifth sounds calm; a fifth that is slightly out beats, a slow wobble in the sound.

New strings stretch for several days, so expect to retune often during the first week. Check the bridge each time: tuning pulls its top toward the fingerboard, and a bridge that leans forward should be eased back upright before it warps.

Viola, cello and double bass

On the viola the A string is again the reference, and the C string is the slow one to settle, because a thick string keeps wobbling in pitch for a moment after each turn. Bow it near the bridge with a little more weight than feels natural and wait a second before trusting the needle.

The cello C string is about 65 Hz, low enough that a laptop microphone across the room may lose it. Point the microphone toward the f-holes from a short distance and bow a long note. Many cellists tune from the A string downward, checking each lower string as a fifth against the one above, and the tuner can confirm each step.

The double bass setting covers orchestral tuning only. Solo tuning, a whole step higher at F#1, B1, E2 and A2, is not in the list; the chromatic tuner reads any note, so use it for solo strings or any scordatura that is not listed here.

Whatever the instrument, tune in the room where you will play and after the instrument has been out of its case for a few minutes. Wood and strings respond to temperature: a cello carried in from a cold car goes flat as it warms, and a viola left by a sunny window drifts the other way. Checking the open strings again just before a lesson or a rehearsal takes seconds and saves the first tune from sounding sour.

Fiddle tunings: cross A, high bass and cross G

Old-time and folk fiddlers retune the violin for particular keys, a practice called cross-tuning. In cross A the strings are A E A E: the G string rises a whole step to A and the D string a whole step to E, so tunes in A ring with open strings an octave apart. High bass, A D A E, raises only the G string to A. Cross G, G D G D, lowers the A and E strings a whole step for tunes in G.

Raising a string adds tension, so bring it up slowly and keep an eye on the bridge. Many players keep a second fiddle in a cross-tuning rather than retuning between sets, because an instrument takes a while to settle after a big change. Return to standard tuning by the same route, one string at a time.

Cross-tunings change which notes ring along. An open string vibrates by itself when its note is played elsewhere, and a tuning built around the key of the tune makes the instrument louder and its drones easier. That is the whole idea, and the tuner only has to get each string to its new note.

Reference pitch: 440, 442 or 432 Hz

Most teachers and practice tracks use A4 = 440 Hz. Many orchestras in Europe and some in the US tune slightly higher, to 442 Hz, which makes a string section sound a touch brighter; if you play with a group, ask which pitch it uses and set the same value here. The 432 Hz option is for players who tune to recordings made at that pitch. No reference is better for the ear or the body; each is a convention.

The reference matters most when you play with instruments of fixed pitch. A piano tuned to 440 Hz cannot follow you to 442, so you tune to the piano. When you practice alone, pick one reference and stay with it, so your ear gets used to one set of open-string pitches.

Getting a steady reading

A violin's sound is rich in overtones, and the second harmonic, one octave above the note, is often as strong as the fundamental. Tuners sometimes jump to the octave for that reason. The tuner on this page compares what it hears with the strings of the chosen instrument, which keeps the note name right; if the needle still jumps, bow more evenly and a little closer to the fingerboard.

Steady background noise matters less than you might expect, because the tuner follows the strongest steady pitch. A television or a second instrument playing another note will confuse it, though, so tune in a quiet moment or hold the phone or laptop closer to your instrument than to the noise. Clip-on tuners that sense vibration through the scroll avoid this problem, which is why many players keep one in the case for rehearsals.

If the browser asks for microphone permission every time, allow it for this site in the browser settings. The tuner listens only while it runs; press the button again to stop it.

Is the violin tuner private?

The pitch is worked out on your device from the live microphone signal. The sound is not saved or sent anywhere, and the reading disappears when you stop the tuner or close the tab.

The instrument you choose is remembered in this browser, so the next visit opens on the same setting. Clear the site data in the browser to forget it.

Frequently asked questions

What are the violin strings from lowest to highest?

G, D, A and E: G3 at about 196 Hz, D4 at 294 Hz, A4 at 440 Hz and E5 at 659 Hz.

Can I tune a viola or a cello with this violin tuner?

Yes. Choose Viola for C3 G3 D4 A4 or Cello for C2 G2 D3 A3. The Double bass setting covers orchestral tuning, E1 A1 D2 G2.

Should I tune my violin to 440 or 442?

Use 440 Hz unless your group plays at another pitch. Many orchestras tune to 442 Hz, which is about 8 cents higher.

Why does the tuner show the right note in the wrong octave?

Bowed strings have a strong overtone one octave up, and the tuner can lock onto it. Pick the right instrument in the list, bow evenly and keep the microphone close to the instrument.

Should I bow or pluck while tuning?

Both work. A bowed note holds still longer, so the needle settles faster; a plucked note fades and its pitch drifts a little as it dies away.

How often should I tune my violin?

Every time you play. Temperature and humidity change the pitch of strings within hours, and new strings keep stretching for several days.

Target frequencies

The tuner compares what it hears with these frequencies (in Hz, A4 = 440 Hz, strings from low to high):

Computed in equal temperament: f = 440 × 2^((n − 69) ÷ 12).
TuningStrings and frequencies (Hz)
ViolinG3 196.00, D4 293.66, A4 440.00, E5 659.26
ViolaC3 130.81, G3 196.00, D4 293.66, A4 440.00
CelloC2 65.41, G2 98.00, D3 146.83, A3 220.00
Double bassE1 41.20, A1 55.00, D2 73.42, G2 98.00
Fiddle, cross A (AEAE)A3 220.00, E4 329.63, A4 440.00, E5 659.26
Fiddle, high bass (ADAE)A3 220.00, D4 293.66, A4 440.00, E5 659.26
Fiddle, cross G (GDGD)G3 196.00, D4 293.66, G4 392.00, D5 587.33

Tools that pick up where this one stops.